This is my first mods project.
What I used:
1 plexiglass 8x8.5 inch will do.
3 LED (Blue)
1 Resistor
20 inches wire
Masking Tape
Soldering tool
Dremel (for creating hole)
Steps
1. Cover the side area (about an inch) with masking tape.
2. Sand the center part and remove all the shiny part. (This is needed as Im using an optical mouse , this kind mouse will not work in a shiny surface.
3. Make 3 hole on the top of the plexiglass.
4. Insert the LED and connect all the LED in a series connection.
5. Connect the resistor by soldering.
6. Connect to the PSU using the black and yellow wire.
7. Finished.
No comments:
Post a Comment